You are not logged in.

#1 2019-03-27 10:06:31

Kidbooo
Member
Registered: 2019-03-27
Posts: 1

Overflow when saving but where

Hello everyone,,
When you save the edited pdf and there is text overflow, Infix shows you where the overflow is.

But sometimes, this function seems to cause the page to 'jump'

Hard to explain but instead of seeing a text box with a blue border around it with a red square (indicating clearly where the problem is), the page just seems to jump for a second and I get no info.

Another question is 'is it possible to deal with text overflow problems one by one' while in save mode

I can see the problems, but can't get into the document at this time to correct them.

So I end up noting them all down on a piece of paper to deal with them after coming out of save.

If you are wondering why I get so many text overflow problems after 'editing' , it is because I translate the document and then reimport the xlm file.

Sometimes, the translation can be longer than the original text.

i can get loads of overflow problems at this stage if I'm unlucky even though I tell INFIX to 'deal with certain text overflow problems where possible.



Thanks in advance cos I know you will answer me on this smile

Offline

#2 2019-03-27 11:15:21

guybushnell
Moderator
From: Norwich, England
Registered: 2013-01-28
Posts: 119
Website

Re: Overflow when saving but where

Hello.
With Infix 7 you get the option to review all the problems at the point of saving. This review lists each problem and helps you to fix it. Have you seen this facility or are you using an earlier version of the software?

Offline

Board footer

Powered by FluxBB