You are not logged in.

#1 2015-03-18 00:17:28

Registered: 2014-12-11
Posts: 4

How to handle tables with the translation process?

the demonstration video for the translation process is very clear and well-done, as are the details in the manual, congrats.
I have to translate a PDF with a single-page table with a lot of columns that shows in Landscape format (A4 turned 90°). My question is: must I still click in any cell to join them for translation or can I directly go to the XML export, assuming that each cell contains a closed sentence, some of them are blank? Generally will the translation process differ for table-only documents?

Thanks to respond.
Best regards,

Last edited by MikeTrans (2015-03-18 00:18:51)


#2 2015-03-18 09:25:53

From: Norwich, England
Registered: 2013-01-28
Posts: 117

Re: How to handle tables with the translation process?

My advice would be to draw a table box around the table, then save the document. Do this before you make any edits to it since the presence of a table box will change the way the paragraphs are detected in the table.
When you reload and begin to export, you should find each table cell exported as a separate paragraph.

Please get in touch again if you have trouble with the document.

By the way, you add a table box using the link tool - it looks like chain links on the tool bar. Once you draw the box, choose Iceni Table Box as the type for the link.


Board footer

Powered by FluxBB